46.
Remove the axle CV shaft from the rear differential. with a
paint pen, mark on the inner and outer CV’s and axle where
they were removed from (drv. rear inner / drv. rear outer)
SEE PHOTO BELOW
47.
If you are installing the optional weld on gusset kit, do so at
this time following those included directions.
48.
Repeat steps eleven through seven-teen for rear CV axle
assembly.
SEE DIAGRAM ON LAST PAGE OF
INSTRUCTIONS FOR CORRECT CV AXLE
IDENTIFICATION. THE REAR AXLES ARE DRIVER
AND PASSENGER SPECIFIC
.
49.
Working from the passenger side, locate the assembled rear
passenger long travel axle and install into the rear
differential. Use a large rubber mallet and tap the outer end
of the axle shaft into the differential. SEE PHOTO BELOW
50.
Locate FT95006GR (driver upper), FT95162GR (driver
lower), FT95008GR (pass. upper), and FT95163GR (pass.
Lower) control arms, FT95000 bushings, FT95004 sleeves,
and the supplied bushing lube. Place a small amount of lube
into each of the barrels on the arms. Using a press, press a
bushing into both ends of each barrel. Place more of the lube
onto the sleeves and use the press to install one into each set
of bushings.
51.
Install the passenger lower a-arm into the factory a-arm
mounts and attach with the factory a-arm hardware. Leave
loose. (use supplied thread-locking compound) SEE
PHOTO IN NEXT COLUMN.
