15.
Locate the Inner CV housing and factory large snap ring
(one wire style). Install the housing onto the axle over the
CV cage and install the large snap ring. Slide the CV boot
over the CV and Housing. SEE PHOTOS BELOW AND
ON NEXT PAGE
16.
Locate two large and two small CV boot clamps from the
FT95060 clamp kit. Position the large clamp around the boot
and axle. Pull the clamp tight around the boot and mark the
clamp where it overlaps at the crimp lock with a paint pen.
Remove the clamp from the boot and cut the excess from the
strap. Repeat this step for the other three clamps on this axle.
SEE PHOTOS BELOW
17.
Using a CV boot band clamp tool, clamp only the inner boot
clamps. Locate one of the supplied CV boot grease bags
( 4
bags are provided with this kit, one for each axle, half a
bag for each CV)
. Carefully pull back the boot from the
inner CV and insert
HALF
of the bag into one inner CV
boot. Re-install the boot onto the CV and use the clamp tool
and tighten the clamp. Repeat this step for the outer CV.
SEE PHOTO BELOW
Mark & cut at
the crimp lock
