18.
Repeat steps eleven through seven-teen for the driver side
CV axle.
19.
Working from the passenger side, locate the assembled front
Long Travel axle and install into the front differential. Use a
large rubber mallet and tap the outer end of the axle shaft.
SEE PHOTO BELOW
20.
Locate FT95002GR (driver upper), FT95003GR (driver
lower), FT95004GR (pass. upper), and FT95005GR (pass.
lower) control arms, FT95000 bushings, FT95004 sleeves,
and the supplied bushing lube. Place a small amount of lube
into each of the barrels on the arms. Using a press, press a
bushing into both ends of each barrel. Place more of the lube
onto the sleeves and use the press to install one into each set
of bushings.
21.
Install the passenger lower a-arm into the factory a-arm
mounts and attach with the factory a-arm hardware (use
supplied thread-locking compound). Leave loose. SEE
PHOTO BELOW
22.
Install the passenger upper a-arm with pre-installed ¾” heim
and jam nut into the factory a-arm mounts and attach with
the factory a-arm hardware. (use supplied thread-locking
compound) Leave loose. SEE PHOTO BELOW
IF YOU ARE INSTLLING THE HEAVY DUTY
STEERING KIT, DO SO NOW FOLLOWING THE
INSTRUCTIONS PROVIDED WITH THAT KIT AND
SKIP STEP 23 IN THIS INSTRUCTION SHEET
23.
Remove the outer tie rod end and leave the factory jam nut
on the inner tie rod end. Locate FT95015 Tie Rod
Extension, FT95203 ½” Male Heim, and supplied ½” jam
nut. Thread the supplied ½” jam nut onto the ½” heim and
insert into the tie rod extension. Thread on the tie rod
extension (end with two reliefs cut into end of extension)
onto the inner tie rod to the factory jam nut. Adjust the tie
rod extension so there is an equal amount of thread on the
½” heim and the factory inner tie rod end
(approx. ½”
above the jamb nut).
SEE PHOTOS IN NEXT COLUMN,
NEXT AND LAST PAGE
