Upper and Lower Control Arm @ Knuckle
28.
Locate FT95020 ½” Short Mis-alignment and the supplied
3/8” x 3 ¼” hardware. Insert the mis-alignment into the top
of the ½” heim in the new extended steering shaft followed
by the 3/8” bolt. Position the ½” heim and hardware onto the
FT95021 steering arm hat and through the knuckle. Place
one of the supplied 3/8” SAE Flat Washers and one of the
3/8” USS Flat Washers on the bottom of the knuckle along
with the 3/8 C-lock nut. Torque upper and lower control arm
bolts to 32 lbs, the 9/16” hardware to 95 lbs, and the 3/8”
hardware to 35 lbs (use supplied thread-locking compound).
Tighten the jam nut on the pre-installed ¾” heim on
the upper control arm
. SEE DIAGRAM ON NEXT
PAGE AND LAST PAGE
New Tie Rod Assembly @ Knuckle
FT95020
½”short mis-
alignment
