FABRICBIKE MINIClassic, Инструкция по сборке

Страница: 8 / 32

8
5. Adjust the height of the stem to your desired level and tighten the stem bolt. You can make final
adjustments to the height of the stem after the bike is assembled (Fig. 9).
6. Using a hex key wrench, loosen the bolt at the front of the stem handlebar clamp (Fig. 7).
7. Lift/rotate the handlebar to desired position. Make sure the handlebar is centered in the clamp.
Tighten the handlebar clamp bolt (Fig. 8).
HANDLEBAR CENTER DIRECTION
1. Make sure the front fork is facing forward (Fig. 1).
2. You may have to loosen the Stem Bolt a few turns (Fig. 9).
3. Align the stem/handlebars with the centerline of the front wheel/tire and fork dropouts - tighten
securely (Fig. 10A).
NOTE: Be sure that the minimum insertion mark on the shaft of the stem is inside the frame. Do
NOT operate the bike if it is visible (Fig. 10).
WARNING!
Adjusting (or installing) the stem with the minimum insertion mark showing outside of the frame
could create a dangerous condition causing the stem to break causing the rider to lose control
resulting in serious injuries to the rider.
STEP 4: FRONT WHEEL
1. Remove the plastic shipping protector from the fork dropouts and plastic axle protector(s).
2. Loosen the axle nuts on the front wheel and insert the front wheel into the fork dropouts. Insert
the tab of the safety washers into the small holes on the outside of the fork dropouts. (Fig. 11).
3. Inspect the wheel to make sure it is centered in the fork (Fig. 12). Tighten each axle nut a little at
a time with a 15mm wrench, alternating between sides. until each axle nut is properly tightened.
STEP 5: FRONT BASKET
1. Loop the mounting straps into the basket slots from the bottom inward and over the basket rim
(Fig. 13). 2. Loop over the handlebar on each side of the stem • pull tight and buckle-up same as
any waist belt (Fig. 14).