FABRICBIKE MINIClassic, Инструкция по сборке

Страница: 9 / 32

9
3. Tuck the strap ends into the keeper loop (Fig. 15).
STEP 6: TIRES
1. Locate the tire manufacturer’s recommended inflation pressure found on the tire sidewall (listed
as “PSI”).
2. Using a hand or floor pump with a gauge, begin to inflate the tire to half its recommended infla-
tion pressure. Check to see that the tire is properly seated on the rim. Be sure to inspect both sides
of the tire for proper fit.
3. If the tire is seated unevenly or bulges out along the rim, let some air out of the tire and reposi-
tion the tire by hand so that it sits evenly on the rim.
4. Continue to inflate the tire to the manufacturer’s recommended pressure.
Do NOT exceed the recommended pressure as this will cause an unsafe condition potentially cau-
sing the tire to unexpectedly explode.
Do NOT
use a compressed air device to inflate your tires. The rapid inflation of the tire can cause it
to blow off the rim.
NOTE: Tires and tubes are not warranted against damage caused by over-inflation or punctures
from road hazards.
SERIAL NUMBERS & CPSC TRACKING NUMBER
It is important you locate and record the Serial Number and CPSC Tracking Number of your bicycle
in case of a recall or if the bicycle is stolen. The Serial Number will be found under the crank bottom
bracket and stamped into the frame (Fig. 16). Depending on model, the CPSC Tracking Number can
be found next to the serial number or at the bottom of the frame seat tube (Fig. 16 & 17).
BEFORE YOUR FIRST RIDE
We strongly recommend you take
your bike to a professional bike shop
and have them
check your work and fine tune the
bike to ensure your bike is safe to ride.