FAAC S800H ENC, Руководство пользователя

Страница: 5 / 20

5 532096 Rev. B S800H ENC
x 1
x 1
A
B
T
ranslation of the original instructions
ENGLISH
-
Ø Cable (max length)
Engine S800H ENC
2x2.5 mm² up to 8m, increase the cross-
section by 0.3 mm² for each additional m
Bus encoder 2x0.5 mm ²
BUS 2 Easy photocells 2x0.5 mm² (max 100 m)
Board power supply 2x2.5+T mm ²
Key-operated button 2x0.5 mm²
Flashing
light 24 V
2
x1.5 mm²
CLOSING LIMIT
SWITCH
4 INSTALLATION OF THE OPERATOR
4.1 OPERATOR WITHOUT EMERGENCY MECHANICAL RELEASE
3) Unscrew the cap (Fig.4 ref.A) on the screw of the closing limit
switch (Fig.4 ref.
) , and make sure that the screw is tightened
all the way.
4)
Loosen the screw of the closing limit switch (Fig.4 ref.B) by one
turn (Important to correctly couple the pinion-splined bush
during installation).
5) Turn the pinion of the operator using the supplied key (Fig.5
ref.
), in the direction the gate closes , until it reaches the internal
stop of the piston and remove the key.
OPENING
LIMIT SWITCH
Turn the key to the mechanical stop
and remove it from the pinion
Fig.3
Fig.4
Fig.5
1) Bring the gate to the open position.
2) Referring to the instructions in chapter 7.1, act on the operator's
hydraulic release by turning the lever
(Fig.1 ref.
) or using the specific key (Fig.1 ref. ) turn the release
screw (Fig.3 ref. ).
3 ELECTRICAL SET-UP
230 V ~ / 50 Hz
o
115 v ~ / 60Hz
(Depending
on control unit
chosen)
Fig.2
6) Without moving the pinion insert the supplied key on the op-
erator (Check the position of the pin on the pinion Fig.6 ref. ) ,
and if needed turn the pinion to correct it (Important to correctly
couple the pinion-splined bush during installation).
NOTE: if necessary, screw the closing limit switch screw slightly.