![background image](http://html1.mh-extra.com/html/faac/estate-swing-e-su-2200-series/estate-swing-e-su-2200-series_instruction-manual_3207289014.webp)
CN2 -
Located on the lower left side of the board, these terminals are outputs for the op-
erator arm(s), gate locks (optional), and lamps (optional).
•
APM1, CHM1 - terminals.
For dual operations these terminals are for the arm that must
move first, for single operations these terminals are the output for controlling the operator
arm.
•
APM2, CHM2 - terminals.
For dual operations
ONLY.
Connect the arm that is to move sec-
ond to these terminals. For single operations nothing should be connected to these terminals.
•
ELS - terminals.
Brief 12V output at beginning of operation cycle, meant for release an elec-
tric lock.
•
LAMP - terminals.
Both a flashing lamp and a courtesy lamp can be connected to these ter-
minals with a power supply of 24V DC and a max output of 15 W. to change between flash-
ing lamps and courtesy lamps, select parameter “G”.
CN3 -
Located on the center bottom of the board, these terminals are for limit switches.
•
COMF -
Common terminal to make the needed normally closed connections for the limit
switches.
•
FCC1 -
Normally closed contact. This terminal is connected with the COMF through the
limit switch. When tripped (connection opened) it stops the motion of the first operator. (
This
terminal must be jumped with COMF)
•
FCA1 -
Normally closed contact. This terminal is connected with the COMF through the
limit switch. When tripped (connection opened) it stops the motion of the first operator. (
This
terminal must be jumped with COMF)
•
FCC2 -
Normally closed contact. This terminal is connected with the COMF through the
limit switch. When tripped (connection opened) it stops the motion of the second operator.
(
This terminal must be jumped with COMF)
•
FCA2 -
Normally closed contact. This terminal is connected with the COMF through the
limit switch. When tripped (connection opened) it stops the motion of the second operator.
(
This terminal must be jumped with COMF)
•
ENC1, ENC2 - terminals. NOT USED
CN4 -
Located on the bottom right of the board, these terminals are for accessories and
safety devices.
•
OPEN A - terminal.
This is the most common terminal for accessories. Accessories utilizing
a normally open contact to set the gate in motion will be attached to this terminal and the
COM terminal (common or also know as ground).
•
OPEN B - terminal.
This terminal is for opening the first leaf only in dual gate operations. It
is a normally open contact that must be used in conjunction with the COM terminal.
•
STOP - terminal.
This is a normally closed terminal that is used for gate motion stopping
emergency commands.
If a safety device is not being used in this terminal the operator
must have a jumper ran from this terminal to the COM terminal in order to operate.
•
FSW CL, FSW OP - terminals.
These normally closed terminals are for safety devices dur-
ing the closing (CL) and opening (OP) cycles of the gate.
If a safety device is not being used
in this terminal the operator must have a jumper ran from this terminal to the COM
terminal in order to operate.
•
COM - terminal.
This is a common, or sometimes referred to as ground, terminal. It is used
in conjunction will
ALL
accessories and safety devices.
!
Содержание Estate Swing e-sU 2200 series
Страница 1: ...Manufactured by...