FAAC Estate Swing e-sU 2200 series, Инструкция по эксплуатации

Страница: 6 / 25

The system display to the below is a
recommended standard system.
Other approved accessories can be
installed. Photo sensors and a flash-
ing light indicating gate movement
is recommended for safety purposes.
! "
To ensure safety and an efficiently operating automated system, make sure the following condi-
tions are observed.
•
Set up physical stop points for full open and full closed. This is man-
datory for this operator.
•
The gate and post must be suitable for being automated. Check that the structure is
sufficiently strong and rigid, and its dimensions and weights conform to those
indicated on page 1.
•
Make sure the leaves move smoothly without any irregular friction during entire travel.
•
Make sure the hinges are in good condition. Ball bearing hinges are ideal for gates weighing
over 200 lbs. or over 10’ in length.
•
Make sure the gate is plumb and level.
•
The fence post must be secured in the ground with concrete. This will prevent
alteration of alignments and leveling during installation and during cycles.
1,2 Estate Swing Operator
3 Photocells (not included)
4 Control board
5 N/A
6 Push button opening device (not included)
7
Receiver extension (not included)
8 12Vdc flashing lamp (not included)
9 Positive stop
10 DC transformer
Notes: 1) When laying electrical cables, use
appropriate rigid and/or flexible tube
2) Do not run any wires in the same conduit as
110 AC power that may be in the area. This
will cause unwanted interference