FAAC DAAB EP104, Инструкция по эксплуатации

Страница: 71 / 74

DAAB STYRAUTOMATIK EP104
71
Instruction manual version 1 for software version 4.04
INSTRUCTION MANUAL FOR DAAB EP104 CONTROL BOARD
E224 Normal power too low, motor 2 Check C240.
E318 Error in loop 1 Are the loop and connectors electrically continuous?
For more troubleshooting tips, see the instruction manual for
the vehicle detector
E319 Error in loop 2
E614 Communication error
Correct polarity in communication cables? Break in
communication cable? Correct settings in both automatic
control units? Is the external unit switched on?
E901 Error in safety edge S.E1 Contact FAAC Nordic AB.
E902 Error in safety edge S.E2 Contact FAAC Nordic AB.
E903 Error in safety edge S.E3 Contact FAAC Nordic AB.
E904 Error in limit switch sensor Contact FAAC Nordic AB.
E905 Error in stop circuit Contact FAAC Nordic AB.
E909 Internal watchdog triggered Contact FAAC Nordic AB.
E910 Clock monitoring error Contact FAAC Nordic AB.
E911 Repeated restart attempts
Short circuit in limit switch or stop circuit? After the problem
is corrected, the unit makes a new attempt to restart after 20
seconds.
E912 Incorrect checksum in flash memory Contact FAAC Nordic AB.
E913 Memory error in RAM Contact FAAC Nordic AB.
E914 Memory error in EEPROM Contact FAAC Nordic AB.
E915 Incorrect EEPROM version Contact FAAC Nordic AB.
E916 Internal test not completed in time Contact FAAC Nordic AB.
E917 Incorrect order of execution Contact FAAC Nordic AB.
E918 Error code list reset
E921
Contactor for motor 1 activated before the
previously activated contactor has been deactivated.
Contact FAAC Nordic AB.
E922
Contactor for motor 2 activated before the
previously activated contactor has been deactivated.
Contact FAAC Nordic AB.
E931 Stop at the same time as an open/close operation.
E932
Open operation at the same time as a close
operation.
E941
Motor 1 running in the wrong direction according
to the encoder setting.
Check that channel C110 is set to the correct side. Check the
motor is running in the right direction.
E942
Motor 2 running in the wrong direction according
to the encoder setting.
Check that channel C120 is set to the correct side. Check the
motor is running in the right direction.
E961 SE1 did not change to low during the external test. Check that the safety edge is functional, if the safety edge is
not functional, set channel C113 to 0.
E962 SE2 did not change to low during the external test. Check that the safety edge is functional, if the safety edge is
not functional, set channel C123 to 0.
E963 SE3 did not change to low during the external test. Check that the safety edge is functional, if the safety edge is
not functional, set channel C133 to 0.
E964
PHOTO did not change to low during the external
test.
Check that the safety edge is functional, if the safety edge is
not functional, set channel C343 to 0.
E971
SE1 did not change to high during the external
test.
Check that the safety edge is functional, if the safety edge is
not functional, set channel C113 to 0.
E972
SE2 did not change to high during the external
test.
Check that the safety edge is functional, if the safety edge is
not functional, set channel C123 to 0.
E973
SE3 did not change to high during the external
test.
Check that the safety edge is functional, if the safety edge is
not functional, set channel C133 to 0.
E974
PHOTO did not change to high during the
external test.
Check that the safety edge is functional, if the safety edge is
not functional, set channel C343 to 0.