FAAC A952, Руководство пользователя, Страница: 63 / 94

A952 61 532310 - Rev.A
10.2 BATTERY KIT
L
Only use the FAAC battery pack supplied, which is
specific for the A952.
The battery kit can be mounted on whichever side of
the A952 you prefer as long as there is enough space
at the side.
The functions selector can also be mounted on
whichever side you prefer, even if there is a battery
kit as long as there is enough space for the selector
to be operated.
1. Remove the access cover. Remove the pre-cut
section of plastic using a cutter.

2. Remove the access cover on the operator
side. Fasten the two sides to the plate us-
ing the 4 screws and then remove the pre-
cut plastic rectangle on the operator side.

3. Place the battery holder unit on the operator
so that side panels coincide. Secure the plate
using the anchors provided according to the type
of material, as indicated in the specific chapter.
4. Insert the bracket into the guide as shown in the
figure. Slide the bracket to the end of the slot
and tighten the screw.
5. Plug the connector of the connecting cable into
the battery board.