FAAC A952, Руководство пользователя, Страница: 62 / 94

A952 60 532310 - Rev.A
10. ACCESSORIES
3. Check that the devices are working properly.
BUS 2EASY DEVICE REGISTRATION
Registration is required:
- When the automation is first started or after the
board has been replaced
- Following any changes (addition, replacement or
removal) of BUS 2easy devices
Board registration procedure:
1. Select function
bu
in programming. When
l l
is released, the display shows the status of the
BUS 2easy devices:
no
No device registered
-
At least one device registered
cc
BUS 2easy line short-circuited *
Er
BUS 2easy line error
* Registration is not possible in this condition.
2. Press and hold the p p and q q buttons simultane-
ously for at least 5 s until
Y
appears. The regis-
tration is complete.
3. Release the
p p
and
q q
buttons. The display shows
the status of the BUS 2easy devices.
4. Check the status of the LEDs on the display.
Registration procedure from KP EVO:
access the Programming/Installation/2 Easy Reg menu.
CHECKING REGISTERED DEVICES
1. Select the function
bu
in basic programming. Af-
ter registering one or more devices, segment 13 on
bu
is on; when a device is activated, the segment
corresponding to the command lights up:
8 8
13
1
2
1 Total opening command
2 Partial opening command
13 At least one device registered
2. Press and hold the
p p
button; the segments relative
to the registered devices will light up.
10.1 BUS 2EASY DEVICES
Single channel FAAC BUS 2easy control devices can be
connected to this board.
L
If no BUS 2easy accessories are used, leave the con-
nector free. Do not bridge.
CONNECTION
2EASY
BUS
2 Easy
BUS
2 Easy
BUS
2 Easy
BUS
Connect the BUS 2easy devices to the BUS connector.
L
The overall length of the BUS 2easy cables must not
exceed 100 m.
The BUS line does not require a matching polarity
connection.
BUS 2EASY CONTROL DEVICES
1. Position the DIP switches to assign the commands.
L
For each control device connected to the BUS 2easy
line, position the DIP switch switches so that only one
command is used on a single device.
DIP switch
1 2 3 4 5
command
0 0 0 0 0 AUTOMATIC OPEN
0 0 0 1 0 EXTERNAL OPEN
0 0 1 0 0 INTERNAL OPEN
0 0 1 1 0 SEMI-AUTOMATIC OPEN
0 1 0 0 0 KEY
0 1 0 1 0 NOT USED
0 1 1 0 0 NOT USED
0 1 1 1 0 NOT USED
1 0 0 0 0 NOT USED
1 0 0 1 0 PARTIAL AUTOMATIC OPENING
1 0 1 0 0 PARTIAL EXTERNAL OPENING
1 0 1 1 0 PARTIAL INTERNAL OPENING
1 1 0 0 0 PARTIAL SEMI-AUTOMATIC OPENING
1 1 0 1 0 PARTIAL KEY
1 1 1 0 0 NOT USED
1 1 1 1 0 NOT USED
2. Register the control devices BUS 2easy (Function
bu
in basic programming)
.