FAAC 940SMT, Руководство пользователя

Страница: 16 / 42

15
ENGLISH ENGLISH
Fig. 30
If there is no play on the coupling, proceed as follows:
•Loosen the two screws (fig. 31 ref.
) on both carriages.
•Slightly move the belt horizontally until the lever moves
smoothly; tighten the screws on the carriages.
Fig. 31
12.1 Installation of internal release knob
•Assemble the release knob as indicated in fig. 32 ref. .
•Press the contrast washer until it fits in the release knob.
•Screw the adjuster, with the relevant lock nuts, on the
internal part of the bracket (fig. 32 ref.
).
•Fit the cable inside the adjuster, threading it through the
washer and the release knob.
•Secure the steel cable with the cable gland and the
appropriate screw (fig. 32 ref.
).
•Pull the cable up to the cable gland stop inside the knob.
•Take the cable sheath against the adjuster (fig. 32 ref.
).
12.2 Motor lock adjustment
•Fully screw the adjuster on the bracket.
•Pull the knob and rotate it through 90° so that it locks on the
bracket.
•Thread the cable (fig. 33 ref.
) inside part , leaving the
sheath at its limit stop.
•Fit the cable on the terminal (fig. 33 ref.
).
•Pull part to its limit stop (compressing the springs) and
tighten the screw of the terminal , thus securing the steel
cable.
•Make sure that the motor lock coupling is clear of the motor
shaft coupling (fig. 30 ref. B).
•If adjustments are required, turn the knob bracket adjuster.
•Release the knob rotating it through 90° and check if the
release is efficient.
A
B
Fig. 32
Fig. 33
12. MOTOR LOCK
The motor lock is a device guaranteeing the leaves are
locked when closed.Installation procedure:
•Secure the motor lock with the two supplied bolts as shown
in fig. 29 ref.
.
•Manually push the lever (fig. 30 ref. ) toward the motor
shaft, checking for correct meshing as per fig. 30 ref. A.
•Move the lever (fig. 30 ref.
) vertically and check if there is
play between the motor-shaft and motor-lock coupling.
Fig. 29