Ezgo 1600xd, Руководство по ремонту

Страница: 148 / 416

4
-10
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
4.2 CHECK AND REPLACEMENT FOR CVT BELT
The width of a new belt is 29.5 mm ( 1.161 in.). Its
max. speed reduction ratio is 3.55 while its max.
speed acceleration ratio is 0.68. Assuming that its
width is reduced to 1 in. due to wear, the max. speed
reduction and acceleration ratio would be 3.22 and
0.76 respectively. Therefore, the maximun speed
would be reduced by 10% and the max. torque at a
low speed would be reduced by 9%.
•
REMARK
CVT speed reduction ratio
UUVW315A
Check the CVT driven pulley clutch buttons (1 and 2)
for wear. Replace them as necessary. 2.
Measure the width of the CVT belt(1). Replace it
with a new one if it has been used for more than
800 hours or its width is 1 in. (25mm) or less. For
replacement, contact your distributor / Dealer. 1.
UUVW336A
How to change the clutch button
REMARK
Insert the tool having the flat end like "-" driver into
the gap of the assembly line of clutch button(1) (for
stopper: black) and then remove the clutch button
upward. In this case, be careful not apply the force
too much as the fixing part under the button may be
broken.
•
UUVW337A
For friction (white) clutch button, turn the sliding flange(1)
to expose the clutch button(2) while pressing the fixing
flange downward and support the wooden block as
shown in the picture above.(Recommended to work with
a helper).
•
UUVW338A
CVT - INSPECTION AND ADJUSTMENT
UTV(EZGO향)_04_CVT.indd 10 UTV(EZGO향)_04_CVT.indd 10 2011-04-04 오후 3:45:43 2011-04-04 오후 3:45:43