Extron electronics PowerCage 401, Руководство пользователя

Страница: 14 / 57

H
Remote RS-232 port — To
control the unit, connect an
RS-232 device to the 3-pole,
3.5 mm captive screw connector
and configure it as follows: 9600
baud rate, 8 data bits, 1 stop bit,
no parity. Wire the connector as
shown in the image on the right.
Do not tin the wires!
Controlling
Device
Ground (G)
Receive (Rx)
Transmit (Tx)
Ground (G)
Receive (Rx)
Transmit (Tx)
Bidirectional
Tx Rx G
RS-232
NOTE: These two ports allow communication to the enclosure and the boards (see
RS-232 Insertion on page 10).
Installing the Transmitter and Receiver Boards into the Enclosure
Any combination of up to four transmitter or receiver boards can be installed in the
PowerCage enclosure. The quantity and type of boards vary depending on the configuration
for each installation site.
Before installing the boards in the enclosure, refer to the model-specific guide for each
PowerCage transmitter and receiver board you are installing. The guides describe the
features of each board and how to set up and cable it.
NOTE: The power supplies and boards are hot-swappable; they can be installed or
removed without turning off or disconnecting the power to the PowerCage enclosure.
ATTENTION:
• Use ESD precautions when installing a board to avoid damaging it. Keep the board
in the anti-static bag until it is needed.
• Prenez les précautions ESD lorsque vous installez une carte afin d’éviter de
l’endommager. Gardez la carte dans le sachet dépoussiérant jusqu’à ce que vous
en ayez besoin.
• Use proper grounding techniques during installation.
•
Utilisez des techniques de mise à la terre correctes pendant l’installation.
1. Where applicable, remove as many blank plates or previously installed boards from the
rear of the PowerCage enclosure as necessary to accommodate the number of new
boards to be installed.
2. Carefully slide the board into the slot, aligning the bottom edge of the board with the left
and right board mounting slides on the bottom of the enclosure slot. Push the board
completely into the slot and finger-tighten the two top screws while pushing in the
screws to secure the board in place.
PowerCage 401 Enclosure • Installation 6