Extreme Networks EN-SLX-9030-48S-4C, Руководство по установке оборудования

Страница: 66 / 114

FIGURE 30 Optical transceiver extraction tool
Precautions specific to transceivers and cables
DANGER
All fiber-optic interfaces use Class 1 lasers.
DANGER
Use only optical transceivers that are qualified by Extreme Networks, Inc. and comply with the FDA Class 1 radiation
performance requirements defined in 21 CFR Subchapter I, and with IEC 60825 and EN60825. Optical products that do
not comply with these standards might emit light that is hazardous to the eyes.
CAUTION
Do not use the port cover tabs to lift the module. They are not designed to support the weight of the module, which can fall
and be damaged.
CAUTION
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the electrical
contacts to ground surface.
Cleaning the fiber-optic connectors
To avoid problems with the connection between the fiber-optic transceiver (SFP+, QSFP, or QSFP28) and the fiber cable connectors,
Extreme strongly recommends cleaning both connectors each time you disconnect and reconnect them. Dust can accumulate on the
connectors and cause problems such as reducing the optic launch power.
To clean the fiber cable connectors, Extreme recommends using a fiber-optic reel-type cleaner. When not using an SFP+ or QSFP
connector, make sure to keep the protective covering in place.
Precautions specific to transceivers and cables
ExtremeSwitching SLX 9030 Hardware Installation Guide
66 9035691-02 Rev AD