Extreme Networks EN-SLX-9030-48S-4C, Руководство по установке оборудования

Страница: 49 / 114

3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 21 Attaching the rear brackets to the rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Flush-rear (recessed) mounting
The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
The illustrations in the rack installation procedures show a 1U device, but the instructions are the same for a 2U device. The
illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a four-post rack:
1. Attaching the front brackets to the rear of the device on page 50
2. Attaching the extensions to the front of the device on page 50
3. Installing the device in the rack on page 51
4. Attaching the rear brackets to the extensions at the front of the device on page 52
5. Attaching the rear brackets to the front rack posts on page 54
Installing the Universal Four-Post Rack Kit (XEN-R000296)
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD 49