Extreme Networks BlackDiamond 8806, Руководство по установке оборудования

Страница: 173 / 200

BlackDiamond 8800 Series Switches Hardware Installation Guide
173
The following are power cord requirements for use on Extreme switches:
Black Diamond SSI 700/1200 W AC PSU Model 60020:
●
The power supply cord must be agency-certified for country of use, and rated at 10A by in-country
regulatory authority.
●
The power supply cord must have an IEC 320 C13, 90-degree angle plug to connect to the IEC320
C14 connector on the power supply.
●
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
●
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
2
) minimum; over 6 feet, the
minimum wire size is 16 AWG (1.0 mm
2
).
BlackDiamond 600/900 W AC PSU, Model 41050/PS 2431:
●
The power supply cord must be agency-certified for the country of use.
●
The power supply cord must have an IEC 320 C13 plug to connect to the IEC320 C14 connector on
the power supply.
●
The power supply cord must have an appropriately rated and approved wall plug applicable to the
country of installation.
●
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
2
) minimum; over 6 feet, the
minimum wire size is 16 AWG (1.0 mm
2
).
Black Diamond SSI DC PSU, Model 60021:
●
The wire must be UL Listed Type TC (Tray Cable), three conductor, 8 AWG, jacketed, and marked
(UL) TC, 90C min.
NOTE
Tray Cable is a UL US only requirement. Outside United States standard 8 AWG (8.35mm
2
), 90C wire is
acceptable.
●
There is no wall plug; 3-conductor wires have been stripped and are ready for connection to DC
power source mains.
●
The device connector is a Molex Shell Connector PN 42816-0312; Molex Pin Connectors PN 42815-
0032.
●
The assembly rating is 75VDC, 30A, (Do not disconnect under load).
WARNING!
When using multiple power supplies, make sure that each power supply is attached to independent circuits breakers.
See PS installation instructions of PS for proper sizing of circuit breaker.
Make sure that the source outlet is properly grounded according to the country’s local electrical requirements before
plugging the AC supply power cord into a PSU.
For specific product input power requirements refer to the data sheet of the product or modular PSU at http://
www.extremenetworks.com or to Appendix B of this guide.