Extreme Networks BlackDiamond 8806, Руководство по установке оборудования

Страница: 111 / 200

BlackDiamond 8800 Series Switches Hardware Installation Guide
111
module is a BlackDiamond MSM, and green injector/ejector release latches indicate that the module is a
BlackDiamond I/O module (see
Figure 67 ).
Figure 67: Colors on Injector/ejector Release Latches
Installing a BlackDiamond 8000 Series Module
You need the following tools and equipment to install a BlackDiamond 8000 series I/O module or MSM:
●
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
Appropriate type of cable for any ports on the module
CAUTION
Although they appear physically similar, BlackDiamond 12800 series modules are not compatible with
BlackDiamond 8800 series hardware. Do not try to install a BlackDiamond 12800 series module in a BlackDiamond
8810 or 8806 chassis.
When you handle modules, optical devices, or other modular accessories, use an ESD-preventive wrist
strap to reduce the risk of electronic damage to the equipment. Transport PC boards only in electrostatic
packaging. Always place PC boards on a grounded surface before working on them.
To install a module in a BlackDiamond 8800 series switch:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle at the top left corner of the chassis.
2 Select a slot for the module. (See “Module Slot Assignments” on page 109 .)
CAUTION
MSMs and I/O modules only fit properly into their designated slots. Forceful insertion into the wrong slot type
can damage the module.
3 Remove a blank front panel from the chassis slot, if applicable.
NOTE
Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure satisfactory
protection from EMI and to maintain adequate airflow through the chassis.
I/O module
release latches
are green
MSM
release latches
are orange