Extreme Networks BlackDiamond 8806, Руководство по установке оборудования

Страница: 112 / 200

Installing Modules and Establishing Initial Management Access
BlackDiamond 8800 Series Switches Hardware Installation Guide
112
4 Remove the module from the antistatic packaging as follows:
a Place the antistatic bag containing the module on a flat ESD-protective surface that is clear of any
debris.
b Break the quality seal, the ESD warning seal, and the Read Installation Note seal.
c Open the antistatic bag and firmly grasp the rail of the module.
d Hold the rail of the module as you pull the antistatic bag off the module.
NOTE
By holding the rail of the module and pulling the ESD bag off the module, you prevent damage to the module
that might be caused by sliding the module on the ESD surface.
Store the module packaging for future use.
CAUTION
To prevent ESD damage, hold the module by the metal rail and front panel only. Never touch the components on
the PCB or the pins on any of the connectors.
5 Verify that the module injector/ejector handles are open ( Figure 68 ).
Figure 68: Injector/ejector Handles in an Open Position
6
Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
CAUTION
Do not slide the module into the open chassis slot if the injector/ejector handles are in the latched position.
7 Use both hands to latch the injector/ejector handles, by simultaneously pushing both handles
toward the center of the module, as shown in
Figure 69 .
EX_123