Extreme Flight 50cc Extra 300 ARF, Инструкция по эксплуатации

Страница: 32 / 39

32
46. Install your rudder servo using the supplied hardware with the
output shaft toward the front of the plane. Depending on the servo
used you may need to lightly sand the sides of the mount to accept
your choice of servo. We recommend the use of one of the new
“mega-torque” standard size servos such as the Hitec HS-5955 or
the JR 8611A or 8711 for this position. You will notice in the
picture we are using the SWB 4” offset rudder arm. We highly
recommend the use of this quality product to ensure correct
geometry.
47. Next let’s install the pull-pull rudder cables. First remove the
covering from the exit slots at the rear of the fuselage as shown.