Extreme Flight 50cc Extra 300 ARF, Инструкция по эксплуатации

Страница: 10 / 39

10
6. Use the manufacturer supplied mounting hardware and install the
elevator servo with the output shaft toward the front of the stab.
Feed the servo wire out of the hole in front of the servo and out of
the root rib. You will need to attach a 36” servo extension to the
servo lead to reach the receiver in the radio compartment. If you
intend to remove your stabs for transport you will need a longer
extension or additional extensions.
7. In this step I will outline the procedure we use to install the hinges.
There are several ways to do this and several adhesives you can
use. We will describe the way we do it, as this method has proven
itself over many years of model building. If you are new to this
type of hinging process then I recommend that you install a single
hinge first just to acquaint yourself with this method. Before
starting the process get a few items together that will aid you as
you proceed. You will need the following items: 30 minute epoxy
(again, we recommend Pacer Z-Poxy), a scrap piece of pushrod or
1/8” dowel, paper towels and denatured alcohol. Locate 3 hinges
per elevator half. You will need to cut 1 hinge just beyond the
second knuckle to clear the fiberglass tube socket in the stabilizer.
Insert the carbon fiber wing tube into the socket while testing for
proper hinge length to avoid damaging the fiberglass sleeve. Mix a
generous batch of 30 minute epoxy. Use the pushrod or dowel to
thoroughly coat and fill the hinge hole with epoxy, then coat the
hinge with epoxy. Push the hinge into its hole until the joint is