Extreme Flight 50cc Extra 300 ARF, Инструкция по эксплуатации

Страница: 11 / 39

11
about a ¼” from its final position and use a paper towel to remove
the excess epoxy that has been forced from the hole. Push the
hinge the rest of the way in and make sure the hinge pin is centered
in the hinge line. Use some denatured alcohol and a paper towel to
remove all excess epoxy, especially on the hinge pin. When you
are satisfied with the result set the surface aside to dry. Position
the drying piece so that any excess epoxy will pool around the rear
of the hinge.
8. When you are comfortable with this process you should be able to
do one side of a surface per batch of epoxy. Glue all hinges into
the stabilizer first. After the glue has set trial fit the elevator to the
stab and adjust if necessary. There should be as little gap as
possible between the stab and elevator. When satisfied with the fit
remove the elevator and repeat the gluing process outlined above.
Be sure to wipe away all excess epoxy! Set aside to dry. Repeat
this process for the other stab/elevator half.
9. After the hinges have dried thoroughly, pull on them to make sure
they are properly installed. The hinges will probably feel a little
stiff as it is almost impossible to get all of the glue out of the joint.
Use a fine tipped hypodermic needle and place one (only one!)
drop of acetone on each side of the hinge pin. Move the elevator
back and forth a few times and you will feel it loosen up.
Be careful to only use one drop as you don’t want to weaken
the glue joint!
Add a drop of penetrating oil to each hinge pin and