Extraflame GABRIELLA PLUS, Руководство пользователя

Страница: 20 / 40

1
2 3
4
5
6
1 4
3
2
5
6
20 ENGLISH
General menu
Go back - exit
Scroll parameters: next (3); previous (2)
Change settings data: increase (4); decrease (5)
Confirm - access menu
J
make sure that there are no resIdues or dIrt at the Bottom of
the Burn pot. the holes at the Bottom must Be Completely free
to Guarantee proper ComBustIon. the "easy setup" funCtIon
Can Be used to adapt ComBustIon Based on the desCrIBed
needs.
BURN POT BOTTOM
FRONT AIR SET
AIR DUCTING SET
EASY SETUP SET
CHRONO ENABLING
PRG1
PRG2
SETTINGS DATE-TIME PRG3
LANGUAGE PRG4
DISPLAY
STAND BY
DELTA-T
FIRST LOAD
DEGREES
RESET
*
TECHNICIANS ONLY
EASY CONTROL
*STOVE STATUS
*TECH
MENU
General WarnInGs
Advice to follow for the first start-ups of the product:
During the first hours of operation, there may be some smoke or
odours, but they are due to the normal “thermal break-in” process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š
Ventilate the room well
Š
If present, remove any majolica or natural stone parts from the
top part of the product
Š
Activate the product at the maximum power and temperature
Š Avoid remaining in the room for a long time
Š
Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
For combustion, do not use elements or substances other than those
indicated in the manual.
Before turning on the product, it is necessary to perform the
following checks:
Š
If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š
The pellet hopper must be fully loaded
Š The combustion chamber and the burn pot must be clean
Š
Make sure that the fire holder, the ash drawer and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š
Check that the power cord is properly connected
Š
The bipolar switch (if present) must be set to position “1”.