Extraflame GABRIELLA PLUS, Руководство пользователя

Страница: 22 / 40

22 ENGLISH
operatIon and loGIC
do not use any type of flammaBle lIQuIds for IGnItIon!
do not alloW the BaG of pellets to Come Into ContaCt WIth the BoIlInG hot stoVe durInG the
fIllInG phase!
In the eVent of ContInued faIlure to lIGht, ContaCt an authorIsed teChnICIan.
IGnItIon
Once the previously listed points have been checked, press key 1 for three seconds to ignite the stove. During ignition, the stove will check
for a flame for a period of 15 minutes. Once the control temperature has been reached, the stove interrupts the ignition phase and switches
to PREPARATION.
preparatIon
During the preparation phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and switch to WORK
Work
In the work phase, the stove switches to the Set Power defined by the user, heating the room until Set Thermostat is achieved. See next
heading.
set thermostat
The Set room thermostat can be set using keys 4 and 5, from LOW-TA - 7°C - 37°C - HOT . If the value is between 07°C-37°C, the stove checks
the room temperature using a probe on the machine. Once the set temperature has been reached, the stove automatically reduces the power,
guaranteeing best comfort and reducing pellet consumption: this process is called “modulation”.
loW-ta / hot
If the Set Thermostat is "LOW-TA" (set under the 7° threshold), temperature checking is entrusted to the additional thermostat contact, thus
bypassing the on-board temperature probe.
If the contact is closed (request), the stove works at the set power.
If the contact is open (fulfilled), the stove works at minimum power.
If the setting is on “HOT” (set above 37°C) the stove always operates at the set power, ignoring the external contact and the temperature probe.
set poWer
Set Power has 5 levels of operation. The power can be changed with keys 2 or 3.
Power 1 = minimum level - Power 5 = maximum level.
Press key 1 to exit and save the change.
auto BloW
During the work phase, the stove cleans the burn pot at regular intervals with the function called "AUTO BLOW".
When this procedure starts, a message is displayed. During the "AUTO BLOW" procedure, the pellet feed slows down and the fumes motor
increases.
After cleaning, the stove resumes operation in normal conditions.
sWItCh-off
Press key 1 for three seconds.
Once this operation has been performed, the appliance automatically enters the switch-off phase, blocking the pellet feed.
The flue gas exhaust motor and the hot air flow motor will remain on until the stove temperature has dropped below the safety settings.
reIGnItIon
The stove can only be re-ignited if the temperature of the exhaust fumes is lower than the preset threshold and the minimum safety time has
passed.