Evoqua WALLACE & TIERNAN DEPOLOX 5 E, Инструкция по эксплуатации

Страница: 66 / 92

66
WT.050.810.040.DE.IM.0817
Retrofit kits, spares and accessories
DEPOLOX
®
5 E flow cell
6.
6.2 Installing retrofit kits
6.2.1 Sensor measuring modules and module SiDiSens
Retrofitting conductivity measurement
Proceed as follows:
1 Isolate the 700 P electronics module or 700 M electronics
module from its power supply. See instruction manual “700 P
electronics module” or „700 M electronics module”.
2 Remove the housing cover of the DEPOLOX
®
5 E flow cell.
3 Take out all sensors from the mounting hole in the cell body
cover and unplug the cable gland from DFMe electronics
module. Hold the cable while doing this as it must not be
allowed to twist.
4 Keep the sensors in a safe place (see instruction manual for
sensors).
5 Disconnect CAN connection cable between DFMe electronics
module and 700 P electronics module or 700 M electronics
module.
6 Remove DFMe electronicselectronics module from the
DEPOLOX
®
5 E flow cell housing. To do this, release the fixing
screw on the underside of DFMe electronics module.
7 Unhook DFMe electronics module from the mounting hook (D
- Figure 2) of DEPOLOX
®
5 E flow cell. To do this, raise DFMe
electronics module and carefully unhook it from the mounting
hook.
8 Open the housing of DFMe electronics module. To do this,
release the four cover screws of DFMe electronics module.
Figure 1 DEPOLOX
®
5 E flow cell, non-pressurized (cover
removed)
A Multi-sensor
B 3-electrode measuring cell
C Cap
A
B
C