Evoqua WALLACE & TIERNAN DEPOLOX 5 E, Инструкция по эксплуатации

Страница: 38 / 92

38
WT.050.810.040.DE.IM.0817
Installation
DEPOLOX
®
5 E flow cell
4.
4.4.3 Installation variant without top-hat rail
Instead of hooking the DEPOLOX
®
5 E flow cell and the 700 P
electronics module or 700 M electronics module onto the top-hat
rail, they can also be hooked onto suitable tallow-drop screws by
the top holding clips.
Please note
The dimensions for the drilling pattern can be found on the back of
the plastic housing.
Proceed as follows:
1 Affix the supplied tallow-drop screws and dowels to the solid
wall. Tallow-drop screws and dowels for fixing to a solid wall
are included in the scope of delivery.
Please note
If the device is to be installed on a suitable lightweight wall, use the
relevant mounting fixtures (not included in the scope of delivery).
2 Hook electronics module into the tallow-drop screws.
3 Fasten the electronics module to the solid wall at the bottom
by the holders using dowels and screws.
4 Hook DEPOLOX
®
5 E flow cell into the tallow-drop screws.
5 Fasten the DEPOLOX
®
5 E flow cell to the solid wall at the
bottom by the holders using dowels and screws.
Please note
If 700 P electronics module or 700 M electronics module and DE-
POLOX
®
5 E flow cell are installed in different locations, you must
use CAN bus extension cable (optional); see chapter 6.4.2 “CAN
bus extension cable”. This must not be longer than 1000 m.