Evoqua WALLACE & TIERNAN DEPOLOX 5 E 700 P Series, Инструкция по эксплуатации

Страница: 58 / 82

58
WT.050.810.040.DE.IM.0519
Retrofit kits, spares and accessories
DEPOLOX
®
5 E flow cell
6.
6.1.2 Retrofitting sensor measuring modules, total chlorine
membrane sensor TC3 CAN and module SiDiSens
conductivity measurement
Proceed as follows:
1 Isolate the 700 P electronics module or 700 M electronics module
from its power supply. See instruction manual “700 P electronics
module” or „700 M electronics module”.
2 Remove the housing cover of the DEPOLOX
®
5 E flow cell.
3 Take out all sensors from the mounting hole in the cell body cover
and unplug the cable gland from DFMe electronics module. Hold the
cable while doing this as it must not be allowed to twist.
4 Keep the sensors in a safe place (see instruction manual for sen -
sors).
5 The pressurized version can be retrofitted with the total chlorine
membrane sensor TC3 CAN. Please note that the standard cell body
cover must be replaced by an optional cell body cover, part no.
W3T417269. Please see chapter 6.1.3 “Replace standard cell body
cover (optional)”.
6 Disconnect CAN connection cable between DFMe electronics mod -
ule and 700 P electronics module or 700 M electronics module.
7 Remove DFMe electronicselectronics module from the DEPOLOX
®
5 E flow cell housing. To do this, release the fixing screw on the
underside of DFMe electronics module.
8 Unhook DFMe electronics module from the mounting hook (D - Fig -
ure 2) of DEPOLOX
®
5 E flow cell. To do this, raise DFMe electron -
ics module and carefully unhook it from the mounting hook.
9 Open the housing of DFMe electronics module. To do this, release
the four cover screws of DFMe electronics module.
Image 1 DEPOLOX
®
5 E flow cell, non-pressurized (cover removed)
A Multi-sensor
B 3-electrode measuring cell
C Cap
A
B
C