30 |
w w w. e v o l v e - f i t n e s s . e u
1.
Observe whether the running belt is toward the right or left side of the deck.
●If toward the left side of the deck, using wrench, turn the left adjustment bolt clockwise 1/4 turn
and the left adjustment bolt counter clockwise 1/4.
●
If toward the right side of the deck, turn the right adjustment bolt clockwise 1/4 turn and the left
adjustment bolt counter clockwise 1/4.
●
If the belt is still not centre, repeat the above step until the running belt is on centre.
2.
After the belt is centre, increase the speed to 16kph and verify that it is running smoothly.
Repeat the above steps if it is necessary.
If the above procedure is unsuccessful in resolving the off-centre, you may need to increase the
belt tension.
LUBRICATION
The treadmill is factory-lubricated. However, it is recommended to check the lubrication of the
treadmill regularly, to ensure an optimal operation of the treadmill. It is usually not necessary to
lubricate the treadmill in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the belt, as
far as possible. If traces of silicon spray are found, lubrication is not necessary.
In case of a dry surface refer to the following instructions. Only use
oil free silicon spray.
Application of lubricant on the belt:
●
Position the belt so that the seam is located in the middle of the plate.
●
Insert the spray valve in the spray head of the lubricant container.
●
Lift the belt at one side and hold the spray valve in a distance to the front end of striding belt and
plate. Start at the front end of the belt. Lead the spray valve in direction of the back end. Repeat
this process on the other side of the belt. Spray each side for about 4 seconds.
●
Wait 1 minute to let the silicon spray spread, before starting the machine.
CLEANING:
Regular cleaning of the striding belt ensures a long product life.