Eventide H8000FW, Руководство по эксплуатации, Страница: 74 / 206

68
Signal Flow Example
Now that you’re familiar with the actual menu pages employed in signal routing, let’s run
through a realistic, but fairly involved signal routing. Four main steps are required for
routing any configuration:
•
Select "sources" for the Main in "input block" at
SETUP
/
inputs
.
•
Select "sources" for DSP A’s inputs at
SETUP
/
dsp A
.
•
Select "sources" for DSP B’s inputs at
SETUP
/
dsp B
.
•
Select "sources" for the
Main out
"output block" at
SETUP
/
outputs
. (Recall
that the analog and AES/EBU outputs are always fed from here.)
Optionally:
•
Select "sources" for the ADAT outputs at
SETUP
/
outputs
(third menu page).
For the H8000FW:
•
Select "sources" for AES11/18 outputs at
SETUP
/
outputs
(fourth menu page).
•
Select "sources" for FIREWIRE1 outputs at
SETUP
/
outputs
(fifth menu
page).
•
Select "sources" for FIREWIRE2 outputs at
SETUP
/
outputs
(sixth menu
page).
Once the routing is configured, you can, at your discretion, change levels at:
•
The analog inputs. Use
LEVELS
/
inputs
•
Use the "bottom" menu page for pre-A/D adjustments.
•
Use the "top" menu page for post A/D adjustments
(note – using the pre-A/D control will
give a better signal)
.
•
The digital inputs. Use
LEVELS
/
inputs
.
•
The inputs to DSP A. Use
LEVELS
/
dsp A
.
•
The inputs to DSP B. Use
LEVELS
/
dsp B
.
•
The outputs of DSP A. Use
LEVELS
/
dsp A
.
•
The outputs of DSP B. Use
LEVELS
/
dsp B
.