Eventide H8000FW, Руководство по эксплуатации, Страница: 120 / 206

114
R
EMOTE
C
ONTROLLING
P
ARAMETERS
Parameters can be remote controlled via MIDI or the
rear panel foot pedal jacks. To remote control a
parameter, first highlight it with the cursor. Here we’ve
highlighted the parameter
mix
.
With the cursor in place, press and hold the
SELECT
key until the screen changes to the
"remote control" menu page. After pressing and
holding the
SELECT
key on the parameter
mix
above,
we arrive at the external modulation menu page shown
to the right.
This is the same menu page we discussed interminably in
External Modulation and Trigger Menu
Pages
on page 99. We won’t rehash it here.
→ To change the "hold time," see Miscellaneous Setup Options on page 144.
After making an assignment, you can exit this screen
by pressing the
*done*
SOFT KEY
. You may notice
that the H8000FW flashes "
Control will be lost
if preset is not saved
" if the parameter you are
remote controlling belongs to a program (as opposed to a "global" parameter such as an
input level). This means that you must
<save>
or
<update>
the program to ensure that
your remote control will still be there the next time you load the program. Of course, if
you don’t care if the remote control is there the next time you load the program, then
don’t worry about it!
→ See Saving a Program on page 131.
Assuming that the
mode
on the above menu page was set to something other than
off
when you exited,
mix
will be underlined. This indicates that it is remote controlled.
The underline blinks to add an element of fun and excitement to the H8000FW’s display
and to cheer you up when you’re feeling glum. You can return to the remote control
menu page by highlighting
delay
and holding the
SELECT
key again. If you change the
mode
to
off
on the "remote control" menu page,
delay
will no longer be underlined and
nothing will blink. How sad.