Eventide H8000FW, Руководство по эксплуатации

Страница: 118 / 206

112
Press and hold the SELECT key for one second. Set
the
mode
to
assign 3
. Press the
*done*
SOFT KEY
to exit.
→ To change the "one second hold time," see Miscellaneous Setup
Options on page 144.
At this point, we’ve assigned the "placeholder" mod 3 to modulate both
S/P DIF in 1
and
A OUT4 Wet/Dry
. Now, let’s "fill in" this "placeholder" with an actual external
controller.
Go to the
external
menu page in the
SETUP
area.
Press the
external
SOFT KEY
repeatedly until you
see "
assign 3 setup
" in the upper right-hand corner.
You can set
mode
to anything you like; we’re going to
set it to
pitch wheel
on
channel omni
(
the
omni
parameter on the
[midi]
menu page in the
SETUP
area needs to be set to
off
in order to assign a specific channel
).
Now, when you move the pitch wheel both
S/P DIF
in 1
and
A OUT4 Wet/Dry
are modulated!
(Select the MIDI
base channel
on the [midi] menu page in the SETUP
area.)
If you actually followed along with your H8000FW, you’d be wise to go back to these two
parameters and set
mode
to
off,
so that your input levels and wet/dry ratios don’t start
doing freaky things in response to the pitch wheel in the future!
The very first time you switch on the H8000FW, you will find that assigns 1-8 are set to
high
- this is so that any programs which use one of these as a volume control input are
not silenced. It is recommended, for the same reason, that, if you change these settings
and then want to remove the change, you set them back to
high
, rather than to
off
.
Remote Controlling the Bypass Functions
It is often necessary to be able to remote control the
system bypass function. For this reason a special
controller has been set up for this purpose. It can be
found under
SETUP/external
. Press this key a few times until you come to it.