Instruction Manual MM850404 ed.05
21
6 OPERATIONS
All the procedures and programming operations on
the 2000 series
, can be made using the keyboard and the display.
N
OTE
:
ALL NUMERIC VALUES SHOWN IN THE FIGURES OF THIS MANUAL ARE INDICATIVE AND LISTED AS AN EXAMPLE
.
The analyzer should be used in environments where the temperature does not exceed the specified limits (from -5°C to
+45°C) and where the relative humidity is lower than 95% non-condensing.
6.1 Flue
Gas
Analysis
6.1.1
Switch the Instument ON
Connect the gas probe to the analyzer as shown in chapter 6.
DO NOT INSERT THE PROBE IN THE CHIMNEY
.
Switch the analyzer on pressing the [
ON
] key. The display will show the following page:
This page changes automatically after a few seconds or if you press a key as follows:
This page changes automatically after a few seconds or if you press a key as follows:
This page displays the seconds remaining until the end of the autozero procedure.
N
OTE
: T
HE ANALYZER MUST DRAW CLEAN AIR FROM THE AMBIENT DURING THE AUTOZERO PROCEDURE
.
O
THERWISE THE
MEASUREMENTS MAY NOT BE ACCURATE AND A SENSOR ERROR MAY OCCUR
.
When autozero procedure finishes, and no error occurs, an beeping sound advises the operator.
G R E E N LINE
E C O LINE
U N I G A S
+
Содержание EcoLine 2000
Страница 53: ...Instruction Manual MM850404 ed 05 53 APPENDIX...
