EURANEG SD4005, Оригинальная инструкция по эксплуатации

Страница: 27 / 34

Page 26 Sensor calibration I Care and maintenance
10. Sensor calibration
Procedure: You can find the video at www.euraneg.com
•
Use the key to open the dispenser housing, open the cover, and remove the
bottle.
•
Open the battery compartment and remove 1 of the 4 batteries or when installing
for the first time insert 3 batteries.
•
Press with two fingers of one hand (e.g. with the thumb and forefinger) the ON /
OFF switch (square shape; schematic illustration point b) and the setting button
for dispensing quantity (round shape; c) at the same time.
•
Install the 4th battery with the other hand while holding both buttons pressed
further.
•
The LED lights up blue once and then blue three times in quick succession - now
release both buttons.
•
Place your hand or object (e.g. white cardboard) in the sensor beam at the
position to which you want to reset the trigger distance (e.g. in the middle of the
inspection window; about approx. 6 to 10 cm below the sensor) as soon as the
sensor has registered your hand, the LED flashes in two colors, slows down and
lastly flashes 1x blue - the setting process is complete.
•
Take your hand / object out of the sensor beam, insert the bottle, close battery
compartment and dispenser. The dispenser is ready for use again.
•
Please check whether the desired release distance is set.
11. Care and maintenance
The dispensers are essentially maintenance-free.
With every bottle change, at least every 3 months you should
1. clean the dispenser with a damp cloth dipped in warm soapy water
2. disinfect of the dispenser housing - the dispenser must not be autoclaved
3. exchange of the roller pump (see 7. Pump replacement).
Batteries should be changed after two years
Attention:
Do not immerse the dispenser in water
Do not use corrosive (chlorine-based) or abrasive cleaners
The dispenser cannot dispense unintentionally when the front cover is open
Should the pump tube be clotted after a long time in service, inserting a new
pump. It is an easier and more cost-effective solution than cleaning
Never dismantle the dispenser or remove parts
The warranty becomes void if the QC seal is damaged!