EURANEG SD4005, Оригинальная инструкция по эксплуатации

Страница: 21 / 34

Page 20
Installation, first use and operation
5. Installation, first use and operation
5.1 Preparation
When unpacking, make sure that the box contains all of the following parts:
1 dispenser with installed jet pump
1 spare pump (jet)
1 plate for wall mounting
1 drip tray
1 bag with 1 key and 3 screws and 3
dowels
4 batteries 1.5 V AA Mignon LR6
1 instruction manual
2 stickers
„Seife“ und „Desinfektion“
5.2 Installation
For wall mounting a drilling machine and a 6mm drill as well as a (cordless)
screwdriver are required. Fixing material is included in the scope of delivery. When
exchanging dispensers, maybe the existing wall-mounting plate can be used.
•
Chose a suitable place for mounting the dispenser (see chapter 13.) Allow
approximately 50 mm space above the wall-mounting plate for mounting or
removing the dispenser
•
Allow enough space underneath the dispenser to open the front cover (with
drip tray optionally attached) fully for easy bottle exchange
•
Suitable installation height: about 130 cm, measured from the floor to the
top edge of the dispenser
•
The wall should be clean, dry and plane; make sure no power lines
or installations are damaged when drilling
Use the supplied fixing material to attach the wall-mounting plate; never
use adhesive strips but you can use the tesa Nie wieder bohren solution
If the dispenser is to be used as a desk unit, adequate stability must be
ensured
– fix it onto the surface underneath, if necessary
•
Fix the wall-mounting plate in the correct
position
•
Use the supplied screws and dowels to do so
•
or use the tesa Nie wieder bohren solution to stick it on the wall