Essilor Pro-E 600 edger, Руководство пользователя

Страница: 22 / 198

◦ No chamfering
9. Size reduction/increase (mm)
10. Manual lens clamping
Press and hold to close the lens clamp shafts manually.
11. Start the edging cycle
The door closing and lens clamping are automatic.
Function also available via the “cycle start” button on the front surface.
Always browse from left to right: depending on your selection, certain menus will be available while
others will not.
Your habits taken into account
The edger memorizes your working habits: as time goes by, the buttons of the functions you use most
often will be displayed by default.
b. Calling up a shape
There are 3 ways of calling up the shape you want to edge:
• Calling up the current job:
> Press to display the shape being processed on the tracer.
• Calling up the number of a shape saved on the tracer:
> Press for a few seconds to open the numeric keypad.
> You can then call up a shape via the ID allocated to it.
• Job call via a barcode:
> Scan the barcode using the barcode reader (optional).
Always lock down your 2 lenses before proceeding with the edging. If a job in the course of modification on
the tracer (display of the symbol beside the reference) is called up on the edger, a warning message is
displayed.
> Press to continue and display the job on the edger. The modifications underway are then ignored.
> Press to prevent the display of the job and finish the modifications underway on the tracer.
A reminder of the type of posiblock required is displayed on the shape. It is crucial to use the proper
accessory to edge the lens. Otherwise, an error message is displayed at the start of the cycle.
c. Lens set-up and feeling
Prerequisite: the lens must be centered and blocked before placing it in the edger.
Pro-E 600_Pro-E 700 > v1 -10.18
22
U
SER
M
ANUAL
> II. E
DGING A LENS