Esse-ti Helpy L300, Руководство пользователя

Страница: 34 / 86

34 PROGRAMMING
Note: if the INSTALLER and the OPERATOR password are the
same (as in the default setting) the device reads the password
as the INSTALLER password.
From the local telephone
ACCESS TO PROGRAMMING
¾
Lift the local telephone handset. The telephone is automatically connected
to handsfree 1.
¾
Dial <INSTALLER OR OPERATOR PASSWORD> (by default:
).
¾
You will hear the dialling tone (one longer tone followed by a shorter
tone).
It is now possible, also without hanging up, insert the programming codes. It is
not necessary to hang up between a code and another or to insert the password
again (please refer to sections “Basic programming” and “Advanced
programming”).
If you hang up, when lifting the handset again you receive the dialling tone and
it is not necessary to insert the password again to go on with programming.
If a programmed code is correct you receive the confirmation tone (3 short
tones), while if it is wrong you receive the error tone (longer continous tones);
in this case you need to hang up to continue.
EXITING THE PROGRAMMING MODE
In order to activate the settings made you must exit the programming mode.
The same procedure will be used as for entering programming:
¾
Lift the local telephone handset. You hear the dialling tone.
¾
Dial <INSTALLER OR OPERATOR PASSWORD> (by default:
).
¾
The telephone is automatically connected to handsfree 1.
Note: the programming mode is automatically exited after 30
minutes.