Esse-ti Helpy L300, Руководство пользователя

Страница: 33 / 86

PROGRAMMING 33
PROGRAMMING
The system can be programmed:
•
Locally by means of a DTMF telephone connected to TEL
•
Remotely by making a call to the device with a multifrequency telephone
or with the Esse-ti remote programmer and management software. The
Automatic Answer function must be active. The function is active by
default.
It is recommended to use the first option to install the device and check the
correct operation. The remote programmer and management and control
software should be used to programme the device and check the settings. In this
manual reference is made to the local programming mode with DTMF
telephone (also valid in case of remote programming mode). For information
on the remote programming mode see the remote programmer manual.
Note: the default value is shown in bold.
Nota: it is possible to listen again to the programmed settings either
locally or remotely by means of a standard telephone. (see
paragrapf “Listening to the settings again” at page 48).
Accessing and exiting programming
In order to programme the device it is necessary to enter (either locally or
remotely) the programming mode. In addition to the INSTALLER password,
the OPERATOR password is used to perform a reduced number of
programming operations In this manual the password that must be entered is
indicated with
9
.
To check whether you are in the programming mode, lift the handset of the
local telephone:
- if you hear the DIALING TONE (1 long tone followed by 1 short
tone, see par. “Tones” at page 82), the device is in programming
mode and you can enter the desired programming codes;
- if you are automatically connected to handsfree 1, the programming
mode has not been entered.