Espa ESAL Base, Руководство пользователя

Страница: 12 / 20

12
3. ADJUSTMENTS
Two push buttons, P1 and P2, allow you to adjust the chlo-
rine production (P2 increases production and P1 reduces
it).
4. ALARMS
The red LEDs indicate the following alarms:
Causes: Corrective action:
The cell is dirty. Remove the cell and clean it.
More salt than necessary has been added. Dilute by adding more water.
LED9: EXCESS SALT
Causes: Corrective action:
The cell is dirty. Clean the cell.
The pool has been filled with fresh water. Add salt to the water.
The pool water needs more salt. Add salt to the water.
LED8: TOO LITTLE SALT
LED7 and buzzer alarm.
LED7 flashes, indicating that gas has accumulated in the
electrolysis cell. The green LEDs column flashes, indicating
that the equipment has cut off the current to the cell.
-“ABSENCE OF WATER FLOW”:
Causes: Corrective action:
The pump has stopped. Restore the water circulation. Once the water flow has
been restored, the alarm will automatically be reset.
Excess hydrogen gas (highly flammable) in the electrolytic Bleed the pipe to eliminate the accumulated gas.
cell, which causes the pump to stop.
There is an air pocket in the cell. Bleed the pipe to eliminate the air pocket.
Incorrect connection of the sensor cable. Check that the sensor cable (white) is properly
connected.
The sensor cable is broken. Check the cable and change it.
The cell sensor is dirty. Remove the cell and clean it as explained in the guide.
The cell sensor is broken. Change the cell.
The equipment is damaged. Contact ESPA technical assistance service.
GB
U S E R G U I D E
The green LEDs (LED1 to LED5) indicate the chlorine pro-
duction: 0%, 25%, 50%, 75% and 100% of the total.
The adjustment is maintained, even when the equipment
is disconnected.