19
Kongsberg X-series
13.
The MRF is now ready to be used.
14.
Bring the material to the front of the
Cutting Table
using the joystick on the
Traverse
or on the
Operator Station
.
19.6.4. End of production
The
Motorized Roll Feeder
is not equipped with an end of roll sensor. It is therefore necessary to make
sure that the material is
not fixed to the core
. Use easy to removable tape or no tape when printing. If
tape can be avoided, this is an advantage, because angular tension is not built up when winding up your
material when printing.
The MRF will stop when the dancer falls to the lowest position (material being pulled off from the core).
The MRF will stop when the dancer is pulled to the highest position (material fixed to core).
Put the Automatic Winding Direction switch (A) back in the neutral position when the roll is finished.
19.6.5. Intelligent vacuum
To ensure maximum blowback when feeding,
Intelligent Vacuum Control
should be disabled in
iPC
, and
all the zones should be opened.
19.7. Safety
• The system is equipped with two
Emergency stop buttons
on each side. The switches are
connected to the safety of the table, which means both the
Cutting Table
and the MRF will stop
operating when pressed.
• The MRF will stop operating if the
DynaGuard safety system
of the table is triggered.
• The
Motorized Roll Feeder
does not have an end of roll sensor. It is therefore necessary to make
sure that the material is
not fixed to the core
. Use easy to removable tape or no tape when printing.
If tape can be avoided, this is an advantage, because angular tension is not built up when winding up
your material when printing. The
Motorized Roll Feeder
will stop when the dancer falls to the lowest
position or is pulled towards the highest position.
204
