19
Kongsberg X-series
7.
Put the feeder bar of the
Cutting Table
down to clamp the material on the conveyor belt.
8.
Adjust the “Edge Control Sensor” bracket by aligning the zero point with the edge of the material.
9.
Unlock the dancer bar. Make sure to turn the locking pin 90° to secure it in the top position.
10.
Use the Manual Jog (D) to find the correct unwind direction (i.e. the direction where the dancer is
lowered). Feed a small amount of material.
11.
Press the Automatic Winding Direction switch (A) in the same winding direction as when using the
manual jog.
12.
Adjust the counter weights to modify the tension on the material. The weights should be placed in
the same position for both sides.
a.
To unlock the counter weight, pull out and turn the locking bolt 90°.
b.
Sliding towards the dancer shaft will result in a higher web tension. Sliding away from the dancer
shaft will result in lower web tension.
203
