Esko Kongsberg X Series, Руководство пользователя

Страница: 148 / 243

13
Kongsberg X-series
How to set Cutting Depth
• When inserting a new Knife Blade ,
align the tip of the knife with the
sliding sleeve and zero the depth
meter (A).
• Then adjust the micrometer screw
(Starret micrometer (218)) until
desired depth is displayed (B).
• During execution, the foot is floating
on top of the material. To adjust the
foot downward pressure, adjust the
Foot pressure screw.
• The pressure should be high enough
to ensure good contact between
the foot and the top of the material,
without scratching the material.
Note: To secure good contact between
the foot and the top of the material, the
foot should be lifted 1 – 1.5 mm (0.4 –
0.6 in) during execution (C). (Tool height
adjustment).
How to change Knife Blade
1.
Remove the knife tool from the Tool Head .
2. Remove the sliding sleeve from the tool.
3. The Knife Blade is held by a hex-screw. A 1.5 mm key will fit.
4. Loosen the hex-screw and insert the new blade.
5.
When inserting the new blade, please make sure that:
a.
The back of the Knife Blade is aligned along the reference edge of the blade socket. (To ensure
blade perpendicularity).
b. 3 mm of the blade protrudes from the blade socket (X-acto #11).
6. Tighten the hex-screws and reattach the knife tool.
For this tool, complete the following adjustments:
Parameter Description
Tool Height The foot should touch the material surface, see above.
Lag Setting The knife lag depends upon the actual knife blade adapter and knife blade.
Tool Rotation Adjust tool angle tangential to moving direction.
Center Offset Adjust tool sideways until centered.
Tool Offset Adjust offset relative to Laser Pointer .
For more information about how to run the adjustment wizards, see Tool Configuration .
148