P
AGE
153
T
UNE
B
ASE
200 I
NSTALLATION
& U
SER
’
S
G
UIDE
- M21201-01A1
!
When batteries need replacement,
the Remote will blink twice with
every key press. Simply replace
them and the remote control will
be restored to its full functionality,
including favorite settings.
A
PPENDIX
H - R
EMOTE
O
VERVIEW
Installing Batteries Into Remote
1.
On the back of the Remote, push the tab and lift off the battery cover.
2.
Obtain two (2) fully-charged AA alkaline batteries. Match the + and – marks on the
batteries to the + and – marks in the battery case, then insert the new batteries.
3.
Press the battery cover back into place. The tab should click when the cover is
locked.
4.
Test the unit by pressing PWR and any mode key (e.g., AUX, CBL, DVD, or RCV). If
the batteries are inserted correctly, the LED will blink once.
Programming the Remote
The Remote can control up to 8 different components. Note that 3 of these are already
used for TuneBase 200, TuneBase 200, and PowerPlay. (For TV/VCR Combo control, see
the next section.) Perform the following instructions for each component you want
controlled:
1.
Turn on a component (e.g., VCR) and, if applicable, insert media, (e.g., cassette or
disc). NOTE: Please read steps 2-4 completely before proceeding. We recommend
highlighting or writing down the codes and device you wish to program before
moving onto step 2.
2.
On the Remote, press a component key once (i.e., AUX, CBL, DVD, TV, RCV). Press
and hold SETUP until the LED blinks twice, then release SETUP.
3.
Use the Manufacturer’s Codes (last section in this appendix) to locate the type of
component and brand name and then enter the first four-digit code for your compo-
nent. If performed correctly, the LED will blink twice.
