P
AGE
36
T
UNE
B
ASE
200 I
NSTALLATION
& U
SER
’
S
G
UIDE
- M21201-01A1
TuneBase 200 Power States: On, Standby, Off
After the TuneBase 200 unit is plugged in, the LED located next to the power button will
flash - when it is finished flashing, the LED will stop flashing and turn OFF. This means
TuneBase 200 is now in a standby or “sleep” mode. Because there is no video, the unit
may appear to be in an OFF mode, however, the unit is actually in standby. You can now
press the Power button (on the front panel or on the remote) once and the display will
appear immediately. The Power LED will turn ON.
To change from the ON mode back to the standby or “sleep” mode, press the Power
button on the front panel or on the remote once.
To reset the TuneBase 200 unit, PRESS and HOLD the Power button for more than 4
seconds and release.
The Power LED light will blink for approximately 3 minutes before
turning OFF. When the light is OFF, you can press the Power button on the front panel
or on the remote.
If power is removed from TuneBase 200 for any reason, including a power outage or if
the unit is unplugged, TuneBase 200 will automatically return to the Standby state as
soon as power is restored. When TuneBase 200 is turned on again, TuneBase 200 will
return to the same source mode that it was in when power was lost.
Please follow the guidelines
regarding Power ON and
Power Standby procedures.
TuneBase 200 has three
power states:
1.
ON - you will see video
output on your display.
The Power LED is lit
constant.
2.
STANDBY or SLEEP - no
video output, the Power
LED is OFF.
3.
OFF - unplugged from the
wall unit.
C
HAPTER
2 - S
ETTING
U
P
T
UNE
B
ASE
200
