ESCALADE GOALRILLA CV B3222W, Руководство пользователя

Страница: 6 / 19

GOALRILLA
TM
ASSEMBLY INSTRUCTIONS (Day 5)
Figure 4
5
5
15
3
3
18
18
19
19
2
Figure 3
Figure 3
Figure 3
26
24
26
48
26
2
2
48
25
25
26
NOTE: It may be necessary to use a rubber mallet
to tap in Pivot Tube.
3. Lay Pole (#2) on its side on two padded saw horses. Attach
Actuator (#16) to Pole (#2) using one bolt (#19), split
lockwasher (#18), washer (#3) and two plastic washers (#5)
to thread into each side of Actuator. See Figure 4. Tighten
bolts tight.
46
4.
NOTE: It is important for the installer to understand the
necessity of the Plastic washers (#5) provided. These
washers adequately space painted parts at all pivot points.
Neglecting the use of these washers will result in rusted
parts.
If Pole Cap (#46) is not already pre-installed insert it
into the top of the Pole (#2). It may be necessary to
use a rubber mallet to tap cap in.
1. Attach Post Brackets (#48) to outside of brackets on back
of Post Assembly (#2). Secure with two Hex Head Bolts (#25),
four Flat Head Washers (#26) and two Locknuts (#24) in
each Bracket (#48). See Figure 3.
TOOLS REQUIRED FOR THE FOLLOWING STEPS
1 - 15/16" open end wrench
1 - 15/16” socket and ratchet (optional) 1 - Level
1 - Tape Measure
1 - Rubber Mallet
1 - Set of Padded Saw Horses
1 - 9/16” Deep Well Socket & Ratchet
1 - 3/4” Socket & Ratchet
1 - 3/4” Open end Wrench
1 - 5-16” Socket Driver
1 - Pair of Safety Glasses
1 - Ladder
1 - Phillips Screwdriver
13
14
2.
1 - Cordless Drill & 9/64” Drill Bit
If not already pre-assembled, slide Plastic Actuator Sleeve
(#15) over Steel Actuator (#16) and place Actuator Cap (#13)
on top.
Align holes in all 3 parts and slide Pivot Tube
(#14) through holes in Actuator Cap (#13) Plastic Actuator
Sleeve (#15) and Steel Actuator (#16) until equal amounts
stick out through both sides of actuator. See
Figure 4 .
6