23.
24.
25.
26.
Use the Backboard Pads as a Template and mark the hole locations on the backboard frame.
Note: Safety glasses required for Step 24.
Drill 9/64 pilot holes through aluminum trim and into Steel backboard frame as shown in
Detail D
.
DO NOT
drill through both
sides of tube.
Note: Cordless drill recommended for screw installation. Do not over tighten screws causing Screws to strip.
Note: To install screws, it will be easier if you use a cordless drill with 5/16” socket (instead of Phillips head.)
Secure Backboard pads using screws provided (
#12
). Start with the Right Board Pad (
#44
) secure it by screwing the top (
#12
) screw
all the way in. Next Insert the other two (
#12
) screws to the pre-drilled holes enough to hold pad but
do not
tighten all the way.
Slide Middle Pad (
#53
) into the (
#44
) pad and insert screw (
#12
) to the pre-drilled holes to hold pad in place.
Do not
tighten all the
way.
Attach Left Board Pad (
#45
) and secure it by screwing the top (
#12
) screw all the way in. Next Insert the other two (
#12
) screws to
the pre-drilled holes to hold pad but
do not
tighten all the way. Slide pads together and tighten all screws at this time.
27.
*Rim not
shown for
clarity.
12
Attach
First
44
53
45
Figure 14
Detail D
Screw #12
Backboard
Pad #44 & #45
Steel Frame
Do not drill top
of steel tube
Figure 13
Note: Make sure (#27) Rim
Pad is installed between Rim
(#28) and Backboard (#23)
INSTALL RIM EXACTLY AS SHOWN. FAILURE
TO DO SO COULD DAMAGE GLASS.
it is level. Finish tightening the four nuts.
Place a level across rim assembly and adjust rim until
22.
Mount Goal Assembly (#28) to Backboard as
shown in Figure 12, using four bolts (#29),
washer (#26) and four nuts (#24). Tighten
Fasteners but leave loose enough to level rim.
21.
NEVER USE RIM WITH COVERPLATE REMOVED!
13
Содержание GOALRILLA CV B3222W
Страница 2: ...2...
