ESCALADE GOALRILLA CV B3222W, Руководство пользователя

Страница: 7 / 19

NOTE: It is important for the installer to understand the
necessity of the Plastic washers (#5) provided. These
washers adequately space painted parts at all pivot points.
Neglecting the use of these washers will result in rusted
parts.
NOTE: All board arms are made of rectangular tubing.
Tightening hardware too tight may damage tubing and
make adjustment of system difficult.
Attach lower arm (#11) to Pole (#2), as shown in Figure 5,
using a bolt (#8), two flatwashers (#3), four plastic washers
(#5) and thin locknut (#4).
Note: make sure "Goalrilla lettering is right side up. Do
NOT tighten bolt (#8) at this time.
5.
Secure Actuator (#16) to Lower Arm (#11) using one bolt
(#8), two flatwashers (#3), four plastic washers (#5) and one
snug but, do not over tighten. Board Arms must pivot freely.
If the four Tube Plugs (#10) are not already installed insert
them into open ends of Lower Arm (#11). It may be necessary
to use a rubber mallet to tap plug in.
6.
7.
Figure 5
5
Figure 6
4
4
thin locknut (#4). See Figure 6. Tighten both bolts (#8)
7