Safety Information
●
The Printer can be only used with the power adapters supplied by this
company, or the printer might be damaged
●
Components included in this package may be damaged by electrostatic
discharge (ESD)
Electrostatic discharge (ESD) wristbands are recommended, to ESD
’
s harm on
the printer
●
To avoid being exposed to high temperature burns, don
’
t touch heated bed and
nozzle of the printer with your hands when the printer is working
●
Minors need to be accompanied by a guardian to use the printer and Keep
away from children as much as possible so as not to cause harm to them
●
Printers must be kept away from water and exposure to rain
●
The printer is designed to work properly at an ambient temperature between
10℃ and 32℃,and humidity between 20% and 50%,Operating outside those
limits may result in low quality models.
●
Please ensure that the distance between the nozzle and the hot bed is at least
0.05mm, so as to avoid damage of the nozzle caused by the impact of the nozzle
on the heated bed
●
In any installation step, if you have any questions, please contact us to get
technical support
●
Do not start the printer until you have finished assembling it. Otherwise,
permanent damage to the printer may be caused and harm the user.
●
After completing the installation of the components, please refer to the
manual instructions again and check whether the cables are installed in place
and whether any metal screws are loose or fall off
●
Make sure the printer power is turned off before installing or removing
printer component.
●
Keep this manual is for future reference
●
Eryone company reserves the right of final interpretation.
5
Содержание ER-20
