Eryone ER-20, Руководство пользователя

Страница: 16 / 30

□ Temperature: This option is related to the automatic temperature
adjustment function setting
□ Temperature: Filament setting
□ Initialize EEPROM: Initializes the EEPROM data
□ Autotemp: Whether to turn on automatic temperature adjustment
(off by default)
□ Min: Minimum value of automatic temperature adjustment
□ Max: Maximum value of automatic temperature adjustment
□ Fact:
Automatic temperature adjustment temperature coefficient
（related to firmware）
□ E in mm3:
This function is used to measure the consumption of
filaments. Whether mm3 is used as the unit or not, off by default.
□ Probe Z offset:
□ Unload mm:
Extruder unload length
□ Load mm :
Extruder load length
Auto leveling sensor key parameter。Adjusting this
parameter can change the offset height of the sensor，Offset point refers to
the height between the nozzle and the hot bed by moving the Z-axis to 0
after the printer is returned to its position with the automatic leveling sensor.
□ Calibrate Z： Auto leveling sensor calibration menu. Entering this
menu can quickly adjust the offset height of the sensor without using other
menus for homing and other operations.
□ Bltouch: Ery sensor control menu. Enter this menu to check whether the
function of the sensor is normal.
□ Outage Recovery:
Power resume print menu. You can turn it on or off.
On by default .
□ Preheat PLA conf: Preheating parameter configuration menu for printer
PLA. On this menu you can adjust the heating temperature values of the
nozzle and the heated bed.
15