Eryone ER-20, Руководство пользователя

Страница: 27 / 30

This section lists just a few common solutions to the problem.If your printer
has a problem not in the list, please visit the Eryone company official forum:
https://www.eryone.com/forum
■ Print layer shift
usually caused by the step loss of the stepping motor, which may be caused by
the following circumstances:
1. The acceleration and speed options in the section parameters are not set
properly
2. If the belt is too loose/too tight, the synchronous wheel cannot grab the belt.
If the belt is too tight, the friction force will be too high, exceeding the
endurance force. of the motor.
3. Please check if any foreign matter has collided with the hot bed or nozzle.
■ Nozzle clogging
Nozzle clogging is a common problem in FDM printing, which can be caused by
many reasons. We give several common solutions
1. The use of poor quality pla filament, poor quality PLA impurities more, it
is easy to clog the nozzle.
2. Check whether the nozzle is broken. If the nozzle hits the heated
bed, the nozzle will be broken.
3. Check the teflon tube regularly. The tube will age if used for a long time. The
simple treatment is to pull it out and replace it (you can also cut off the aged
part of the tube).Notice that when you have finished cleaning, re-insert it into
the bottom of the heated end.
4. Change nozzle
■ The print cannot stick to build plate
This problem is usually caused by improper leveling. There are some
differences between PLA and PETG leveling, which can occur when you switch
from PLA to PETG.A re-calibration of the sensor is required to correct this
problem using the
“
Calibration Z
”
function
Trouble shooting and printer maintenance
26